Grizzly G9972Z Owner's Manual page 15

4.
Figure 6
Figure 6.
NOTICE
Make sure the lifting straps are between the
leadscrew and bedway to avoid bending the
leadscrew when lifting the lathe.
5.
6.
Note: If necessary, move the carriage or
tailstock to help balance the load.
7.
Note: Re-check the bedway after 24 hours,
after two weeks, then annually to make sure
it remains level.
Mounting
Figure 7.
Figure 8.
Note: We recommend using a silicon sealant
between the flat washers and the chip pan to
avoid coolant or other fluids leaking through onto
the bench or floor.
Figure 7
Figure 8