Feed Rate
Recommended Feed Rates
Rough Cuts
Note: These values are a guideline only. Refer
to the MACHINERY'S HANDBOOK for more
detailed information.
Figure 40.
Figure 42.
Figure 40
Finish Cuts
The V-belt, change gears,
and pulleys represent
a serious entanglement
hazard when the lathe
is running. Always dis-
connect the lathe from
power before opening
the change gear cover.
Figure 41
Note: This lathe is shipped with the 24 tooth gear
installed in the "a" position, and the 84 tooth gear
in the "b" position.
b
Figure 41.
a