Daewoo Solar 300LC-V Manual page 28

TRAVEL PRECAUTIONS
Never turn the starting switch to the "O" (OFF) position when traveling. It is dangerous if the engine stops
when the machine is traveling. It will be impossible to operate the steering.
Attachment control levers should not be operated while traveling.
Do not change selected travel mode (FAST/SLOW) while traveling.
Fold in work equipment so that the outer end of the boom is as close to the machine as possible, and is 40-
50 cm (16 - 20 in) above ground.
Never travel over obstacles or slopes that will cause the machine to tilt severely. Travel around any slope or
obstacle that causes the machine to tilt 10 degrees or more to the right or left, or 30 degrees or more from
front to rear.
Do not operate the steering suddenly. The work equipment may hit the ground and cause the machine to
lose its balance, and this may damage the machine or structures in the area.
When traveling on rough ground, travel at low speed, and avoid sudden changes in direction.
Always keep to the permissible water depth. Permissible water depth is to the centerline of the upper track
rollers.
When traveling over bridges or structures on private land, check first that the bridge or structure can
withstand the weight of the machine. When traveling on public roads, check with the local authorities and
follow their instructions.
TRAVEL POSTURE
INCORRECT
40 ~ 50 cm (16 ~ 20 in.)
ARO1280L
Figure 17
S0102000 Track Excavator Safety
Page 20