Power On, Power Off, Reboot; Maintenance - Newland NLS-HR1580-BT User Manual

Power On, Power Off, Reboot

Power on the scanner
Hold down the trigger on the scanner until it beeps.
Note: When using the scanner for the first time or after scanning the Battery Off barcode in Chapter 3, you MUST insert
the scanner in a powered cradle to exit battery protection mode before turning it on.
Power off the scanner
Method 1: When in the Level scan mode, the scanner will automatically power off after a specific period of inactivity
(default: 5 minutes, programmable). To change the period, see the "Auto Power-Off Timeout" section in Chapter 3.
Method 2: Scan the Power Off Scanner barcode in Chapter 3.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, press and hold the Reset button on the bottom of the scanner
with a straightened paperclip to reboot it.

Maintenance

 The scan window should be kept clean.
 Do not scratch the scan window.
 Use soft brush to remove the stain from the scan window.
 Use the soft cloth to clean the window, such as eyeglass cleaning cloth.
 Do not spray any liquid on the scan window.
 Do not use any detergent to clean other parts of the device except for water.
The warranty DOES NOT cover damages caused by inappropriate care and maintenance.
11