Table of Contents
Advertisement
1.3.
Boxes and connectors – video interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options. Further it reads the vehicle's digital signals out of the vehicle's CAN-bus and
converts them for the video interface.
1.4.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the dip-switches of the
video interface.
Dip position down is ON and position up is OFF.
Dip
Function
1
Frontkamera
Power supply
output
(red wire)
2
CVBS Video 1-input
3
CVBS Video 2-input
4
PDC
5
Rear-view cam type
6
Guide lines
7
Monitor-specific
adjustments
8
*The front camera will automatically be switched for 10 seconds after disengaging the
reverse gear.
After each Dip-switch-change a power-reset of the Can-box has to be performed!
See the following chapters for detailed information.
Version 21.03.2022
ON (down)
enabled*
+12V (max. 3A) when reverse gear
is engaged incl. 10 seconds delay
and +12V by manual switching to
front camera by keypad
enabled
enabled
enabled
after-market
enabled
Try all possible combinations of dip 7 and-8 to find the
best picture (quality and size)
HW:CAM (V100)/(V42,V43,V44)
OFF (up)
disabled
+12V (max. 3A) ACC
disabled
disabled
disabled
factory or none
disabled
CI-RL4-C3D
Advertisement
Table of Contents
