Table of Contents
Advertisement
1.3.
Connectors – video interface
The video-interface converts the video signals of connected after-market sources in a factory
monitor compatible picture signal which is inserted in the factory monitor, by using separate
trigger options. Further it reads the vehicle's digital signals out of the vehicle's CAN-bus and
converts them for the video interface.
1.4.
Dip-switch settings – video interface
Some settings must be selected by the dip-switches on the
video-interface. Dip position down is ON and position up is OFF.
Dip
Function
1
No function
2
CVBS AV1-input
3
CVBS AV2-input
4
No function
5
Rear-view cam type
6
Monitor specific
7
adjustments
8
After each Dip-switch-change a power-reset of the Can-box has to be performed!
See following chapters for detailed information.
ON (down)
-
enabled
enabled
-
after-market
Try all possible combinations of Dips 6, 7 and 8 to receive
the best picture (quality and size)
OFF (up)
set to OFF
disabled
disabled
set to OFF
factory or none
Advertisement
Table of Contents
