Connection With The Mains - PROEL TARKUS 575 SPOT User Manual

If you are using controllers with this occupation, you can connect the DMX-output of the
controller directly with the DMX-input of the first fixture in the DMX-chain. If you wish to
connect DMX-controllers with other XLR-outputs, you need to use adapter-cables.
BUILDING A SERIAL DMX-CHAIN:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the
next fixture. Always connect one output with the input of the next fixture until all fixtures
are connected.
CAUTION:
For all installation, having long signal
cables or in the presence of electrical
noise, for example a discotheque, it is
recommended practice to use a DMX
terminator: this assist in preventing
corruption of the digital control signal by
external noise. The DMX terminator is
simply an XLR connector with a 120Ω
(Ohm) resistor connected across pins 2
and 3, which is then plugged into the
DIGITAL THRU socket on the last
projector in the chain. The connections
are illustrated on the right.

CONNECTION WITH THE MAINS

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
brown
blue
yellow / green
The earth has to be connected
Lighting effects must not be connected to dimming-packs.
Pin International
live L
neutral N
earth
26