Table of Contents
Advertisement
Proline Kryomats
7.10 Timer function
Using the timer function, the thermostat can carry out an action at a certain time or after a certain
waiting period. The actions are: switching on the thermostat, entering the standby mode or one of the 5
programs in the programmer.
Command
Pump
Settings
Graph
Clock
Programmer
Interfaces
Control
Limits
Pump
Menu
Please exercise caution when thermostat is in standby mode. ( 7.5.3)
A previously activated timer mode could unintentionally start the thermostat again from
the standby mode.
Status
Function
Action
Set Time
Set Date
Pump
Menu
YAUE0007 / 10/2/2018
Set time
Set date
Timer 1
Timer 2
Format of date
End
T
T
set
Weekplan
Time absolute
Time relative
End
T
T
set
Starting up
Clock
Open the device parameter menu via the
soft key
With the cursor keys continue to:
Clock
or to
Timer 2
with the menu
is switched
The standby key
timer!
fix
The menu
when an action is executed:
Similar to an electronic mains timer,
Weekplan
to be carried out each day. The cycle is
repeated after 7 days.
Time absolute
on which a once-only action (switching
event) occurs. The time point is set with
Set time
Time relative
after which a once-only action occurs.
fix
With
Set time
entered. ("Set date" is masked out with
this function selection).
If the
Weekplan
window only
Weekplan
Timer 1
Timer 2
Menu .
Timer 1
,
,
Status
the selected timer
off
or
on
.
does not stop the
Function
is used to define
enables two switching events
defines a time and a date
and with
Set date
.
defines a waiting period
up to 99h: 59min can be
is activated, in this
Status
,
Function
are displayed.
and
81
Advertisement
Table of Contents
