Table of Contents
Advertisement
Helios PD2-6100 Strain Gauge, Load Cell, and mV Meter
Setting the Display Parameter &
Intensity (dsplay)
Display line 1 (line 1) can be programmed to
display:
1.
Process value 1 (PV1)
2.
Process value 2 (PV2)*
3.
Percent of PV1 (PCt)*
4.
Relay set points
5.
Toggle process value & units
6.
Max & min values
7.
Gross value
8.
Toggle net & gross values
9.
Input millivolts
10. Modbus input
Display line 2 (line 2) can be programmed to
display:
1.
Engineering units or custom legends
2.
Process value 1 (PV1)
3.
Process value 2 (PV2)*
4.
Percent of PV1 (PCt)*
5.
Relay set points
6.
Toggle process value & units
7.
Max & min values
8.
Gross value
9.
Toggle net & gross values
10. Input millivolts
11. Modbus input
12. Off (no display)
*These menu items will only appear if Dual-Scale
feature is turned on.
After setting up the input and display, press the Menu
button to exit programming and skip the rest of the
setup menu. Press the Menu button again and the Up
arrow to reach the Program menu and complete the
scaling or calibration of the meter.
Display Intensity (d-Inty)
The meter has eight display intensity levels to give the
best performance under various lighting conditions.
Select intensity 8 for outdoor applications. The default
intensity is 6.
Display Toggling Between Reading
& Units with Tag
The PD2-6100 can be programmed so that line 1
toggles between the reading and units and line 2
displays a tag. For instance, line 1 toggles between
9500 and Lbs and line 2 displays Tank 1.
Display Parameter Menu
Dual-Scale Display Feature
The dual-scale feature is of particular value in
weighing applications where a second scaled display
can represent the measured input in a different form
(i.e. pounds & height). Both displays are
independently scaled and are based on the millivolt
input signal.
32
Instruction Manual
Advertisement
Table of Contents
