Table of Contents
Advertisement
Helios PD2-6100 Strain Gauge, Load Cell, and mV Meter
Compliance Information
Safety
UL & C-UL
USA & Canada
Listed
UL 508 Industrial Control Equipment
(USA)
C22.2 No. 142 (Canadian National
Standard)
UL File Number E160849
Enclosure
UL Type 4X, NEMA 4X, IP65
Low Voltage
EN 61010-1
Directive
Safety requirements for measurement,
control, and laboratory use
Safety Information
•
Read complete instructions prior to installation
and operation of the meter.
•
Risk of electric shock or personal injury.
•
Hazardous voltages exist within enclosure.
Installation and service should be performed only
by trained service personnel.
Installation
There is no need to open the clear plastic front
cover in order to complete the installation, wiring,
and setup of the meter. All programming is done
using
MeterView Pro
buttons and switches located under the lower
door panel and are accessible by removing the
single securing screw. Wires should be run
through the knockout holes located on the bottom
of the meter, see Figure 5. Conduit Holes
Location – Bottom View on page 12 for details.
There are a total of four pre-drilled conduit entry
holes located at the bottom of the meter. If the
need to drill additional holes arises, make sure
you will have the clearance necessary for conduit
mounting hardware.
Do not disconnect the RJ45 connector found on
the right side of the meter wiring board. Doing so
will disable the on-board digital I/O, RS-485 serial
communications, and M-Link functionality.
Instructions are provided for changing the
transmitter power supply to output 5 or 10 VDC
instead of 24 VDC, see Sensor Excitation
Voltage Selection (EX+, EX-) on page 15.
Unpacking
Remove the meter from box. Inspect the
packaging and contents for damage. Report
damages, if any, to the carrier.
If any part is missing or the meter malfunctions,
please contact your supplier or the factory for
assistance.
11
Instruction Manual
software or through the
Advertisement
Table of Contents
