Table of Contents
Advertisement
Helios PD2-6100 Strain Gauge, Load Cell, and mV Meter
Wall Mounting Instructions
The meter can be mounted to any wall using the four
provided mounting holes. Note that the bottom
mounting holes are located underneath the lower door
panel. To mount the meter to a wall, follow these
instructions
•
Prepare a section of wall approximately 11" x 13"
(280 mm x 330 mm) for meter mounting by
marking with a pencil the mounting holes (shown
in Figure 1) on the wall.
•
Select the appropriate mounting screws for the
mounting surface to be used. The mounting holes
diameter is shown on Figure 2.
Note: Mounting screws are not included.
•
Using a drill bit slightly smaller than the girth of
the mounting screws, pre-drill holes at the
mounting locations previously marked.
•
Insert mounting screws into the four mounting
holes and screw them into the pre-drilled holes.
DO NOT overtighten the mounting screws as it is
possible that the enclosure could crack and
become damaged.
Mounting Hole
Lower
Door
Panel
Mounting Hole
Figure 1. Meter Mounting Holes Location
10.43" (265 mm)
11.14" (283 mm)
Figure 2. Meter Mounting Holes Dimensions
Mounting Hole
Mounting Hole
Dia. 0.2"
(5.5 mm)
Dia. 0.2"
(5.5 mm)
12
Mounting Dimensions
4.77"
(121.2 mm)
2.63" (67 mm)
Figure 3. Meter Dimensions – Side View
Mounting Hole
12.59" (319.7 mm)
Figure 4. Meter Dimensions - Front View
Conduit Holes Location
0.9"
(23 mm)
1.99"
1.1"
(50.5 mm)
(27.9 mm)
Plugged
Holes
Figure 5. Conduit Holes Location – Bottom View
Instruction Manual
Mounting Hole
Lower
Door
Panel
Ø0.74" (18.9 mm)
Drill or Punch-Out Holes
Unplugged
Holes
Advertisement
Table of Contents
