Table of Contents
Advertisement
Network Speed Dome User Manual
4. Click
alarm, notify surveillance center, send email and trigger alarm output are
selectable. Please Step 3 in Section 5.2.1 Configuring Motion Detection.
5. Click
5.2.3 Configuring Video Tampering Alarm
Purpose:
You can configure the speed dome to trigger the alarm actions when the lens is
covered.
Steps:
1. Enter the video tampering Settings interface:
Configuration > Event > Basic Event > Video Tampering
2. Check Enable checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 1 in Section 5.2.1 Configuring Motion
Detection.
4. Click
tab to select the linkage method taken for the video loss
to save the settings.
Figure 5-18 Tampering Alarm
tab to enter the arming schedule setting interface. The
58
Advertisement
Table of Contents
