Table of Contents
Advertisement
45
Network Speed Dome User Manual
Chapter 5 System Configurations
5.1 Storage Settings
Before you start:
To configure record settings, please make sure that you have the network storage
device within the network or the storage card has been inserted in the corresponding
card slot. Refer to the installation guide for the location of the storage card slot.
5.1.1 Configuring Recording Schedule
Before you start:
Please make sure a local storage card is inserted in the speed dome or the network
storage is added to the speed dome, and the
Purpose:
There are two kinds of recording for the speed domes: manual recording and
scheduled recording. In this section, you can follow the instructions to configure the
scheduled recording. By default, the record files of scheduled recording are stored in
the SD card (if supported) or in the network disk.
Steps:
1. Enter the Record Schedule Settings interface:
Configuration > Storage > Schedule Settings > Record Schedule
Figure 5-1 Recording Schedule Interface
2. Check the checkbox of Enable to enable scheduled recording.
3. To set the advanced settings of the speed dome, click
to enter the
Advertisement
Table of Contents
