HIKVISION DS-2DF8836IX-AEL User Manual page 73

Network Speed Dome User Manual
2. Configure the following settings:
Basic Parameters: Enable/disable proportional pan and preset freezing, set the

preset speed, keyboard control speed, and auto scan speed.
 Proportional Pan: If you enable this function, the pan/tilt speeds change
according to the amount of zoom. When there is a large amount of zoom, the
pan/tilt speed will be slower for keeping the image from moving too fast on
the live view image.
 Preset Freezing: This function enables the live view to switch directly from
one scene defined by a preset to another, without showing the middle areas
between these two, to ensure the surveillance efficiency. It can also reduce
the use of bandwidth in a digital network system.
Preset freezing function is invalid when you calling a pattern.
 Preset Speed: You can set the speed of a defined preset from 1 to 8.
 Keyboard Control Speed: Define the speed of PTZ control by a keyboard as
Low, Normal or High.
 Auto Scan Speed: The dome provides 5 scan modes: auto scan, tilt scan,
frame scan, random scan and panorama scan. The scan speed can be set from
level 1 to 40.
 Zooming Speed: The zoom speed is adjustable from level 1 to 3.
 Manual Control Speed: The manual control speed can be set as Compatible,
Pedestrian, Non-motor Vehicle, Motor Vehicle or Self-adaptive.
 Compatible: The control speed is same as the Keyboard Control Speed.
 Pedestrian: Choose the Pedestrian when you monitor the pedestrians.
 Non-motor Vehicle: Choose the Non-motor Vehicle when you monitor the
non-motor vehicles.
 Motor Vehicle: Choose the Motor Vehicle when you monitor the motor
vehicles.
 Self-adaptive: You are recommended to set the Self-adaptive when the
application scene of the speed dome is complicated.
PTZ OSD: Set the on-screen display duration of the PTZ status.

 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds,
10 seconds, Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Preset Status: Set the preset name display duration while calling the preset as
2 seconds, 5 seconds, 10 seconds, Always Close or Always Open.
Power-off Memory: The dome can resume its previous PTZ status or actions after

it restarted from a power-off. You can set the time point of which the dome
resumes its PTZ status. You can set it to resume the status of 30 seconds, 60
seconds, 300 seconds or 600 seconds before power-off.
3. Click to save the settings.
72