Table of Contents
Advertisement
Next steps
1
Install the expansion card riser
2
If applicable, connect the cables to the expansion card(s) in the expansion card riser 1A.
3
Follow the procedure listed in
4
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5
Enter the correct time and date in the System Setup Time and Date fields.
6
Exit the System Setup.
USB module
Removing the USB module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the backplane
4
Remove the air
shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
NOTE:
The procedure to remove the USB 3.0 and USB 2.0 modules is similar.
Steps
1
Disconnect the USB cable from the USB connector on the system board. For more information, see the System board jumpers and
connecters section.
2
Using Phillips #1 screwdriver, remove the screws on the USB module.
3
Slide the module out of the system until it is free of the USB module slot on the front panel.
146
Installing and removing system components
1A.
After working inside your
Safety
instructions.
Before working inside your
cover.
system.
system.
Advertisement
Table of Contents
