Installing The Stopper Assembly - Black Horse Model HAWKER TYPHOON MK1B Instruction Manual Book

HAWKER TYPHOON MK1B
INSTALLING THE THROTTLE - CABLE.
 1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
- Item code: BH132
Throttle servo.
Throttle cable.
Instruction Manual
.
FUEL TANK.

INSTALLING THE STOPPER ASSEMBLY

 1) The stopper has been pre-assembled
at the factory.
 2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel line
is calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
 3) Carefully bend the second nylon tube
up at a 45 degree angle (using a cigarette
lighter). This tube will be the vent tube to the
muffler.
 4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
13