Installing The Engine Mount; Installing The Stopper Assembly - Black Horse Model Midget Mustang Instruction Manual Book

MIDGET-MUSTANG -

INSTALLING THE ENGINE MOUNT.

See pictures below:
4x 30mm
4x 30mm
Drill a hole
5mm diameter
Item code: BH83.
INSTRUCTION MANUAL
FUEL TANK.

INSTALLING THE STOPPER ASSEMBLY

1) The stopper has been pre-assembled
at the factory.
2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel line
is calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
3) Carefully bend the second nylon tube up
at a 45 degree angle (using a cigarette lighter).
This tube will be the vent tube to the muffler.
4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
When the stopper assembly is installed
in the tank, the top of the vent tube should
rest just below the top surface of the tank.
It should not touch the top of the tank.
11