Table of Contents
Advertisement
BLADE -
ITEM CODE: BH70-A.
Pushrod wire
Left side.
FUEL TANK.
INSTALLING THE STOPPER ASSEMBLY
1. The stopper has been pre-assembled at
the factory.
2. Using a modeling knife, cut one length of
silicon fuel line (the length of silicon fuel line is
calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
3. Carefully bend the second nylon tube up
at a 45 degree angle (using a cigarette lighter).
This tube will be the vent tube to the muffler.
4. Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
10
Right side.
in the tank, the top of the vent tube should
rest just below the top surface of the tank.
It should not touch the top of the tank.
tank. It may be necessary to remove some of
the flashing around the tank opening using
a modeling knife. If flashing is present, make
sure none of it falls into the tank.
INSTRUCTION MANUAL
When the stopper assembly is installed
5. Test fit the stopper assembly into the
Silicon tube
not included.
Vent tube
Fuel fill tube
Fuel pick- up tube
Advertisement
Table of Contents
