Page 1
Instruction Manual book SPECIFICATION Wingspan : 3,400 mm 133.86 in. Length 1,450 mm 57.09 in. Weight 3,0 kg 6.6 Lbs. Radio 05 channels.
Page 2
INSTRUCTION MANUAL Item code: BH88. This instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your MINIMOA. Use the parts listing below to identify all parts. WARNING. Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing injury to people or property.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. + Do not flip the propeller with your fingers. SAFETY PRECAUTION. + Keep loose clothing and wires away from + This is not a toy the propeller. + Be sure that no other flyers are using your + Do not start the engine if people are near.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. C/A glue I. AILERON. 1.INSTALLING THE AILERON SERVOS. 1) Install the rubber grommets and brass eyelets onto the aileron servos. C/A glue C/A glue Bottom side Aileron C/A glue C/A glue...
Page 5
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Remove covering 2x10mm. Secure 3) Using the thread as a guide and using masking tape, tape the servo lead to the end Secure of the thread: carefully pull the thread out.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Repeat the procedure for the other wing half. 3.INSTALLING THE AILERON LINKAGES. Installing the air brake linkages as pictures below. M2 lock nut 65 mm Top side...
Page 7
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Bottom side Top side C/A glue C/A glue C/A glue Bottom side C/A glue Top side Servo tray. Top side...
MINIMOA - INSTRUCTION MANUAL Item code: BH88. HORIZONTAL STABILIZER. See pictures below: Bottom side ELEVATOR INSTALLATION. SERVO INSTALLATION. 1. Install the rubber grommets and brass collets into the elevator servo. Test fit the servo into the servo tray. C/A glue ...
Page 10
MINIMOA - INSTRUCTION MANUAL Item code: BH88. C/A glue Secure. Bottom side ELEVATOR CONTROL HORN PUSHROD INSTALLATION. Elevator control horn install as same as the C/A glue way of aileron control horn. Please see pic- tures below. M3 lock nut.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Elevator E l e v a t o r pushrod pushrod Elevator control horn. ELEVATOR PUSHROD INSTALLATION. Elevator pushrod install as same as the way of aileron pushrod. M2 lock nut.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. VERTICAL INSTALLATION. Rudder servo install as same as method of elevator servo. See picture below: C/A glue C/A glue C/A glue C/A glue Using a modeling knife cut away the cover- ing from the end of fuselage for the rudder...
MINIMOA - INSTRUCTION MANUAL Item code: BH88. RUDDER PUSHROD INSTALLATION. RUDDER CONTROL HORN INSTALLA- Rudder pushrod install as same as the way TION. of aileron pushrod. Rudder control horn install as same as the way of aileron control horn. Please see pic- tures below.
MINIMOA - INSTRUCTION MANUAL Item code: BH88. SERVO INSTALLATION. INSTALLING THE RECEIVER AND BATTERY. 1. Plug the servo leads and the switch lead into the receiver . You may want to plug an aileron extension into the receiver to make...
MINIMOA - INSTRUCTION MANUAL Item code: BH88. WING ATTACHMENT. Locate the carbon tube wing dihedral brace. *** Test fit the carbon tube dihedral brace into each wing haft. The brace should slide in eas- ily. If not, use 220 grit sand around the edges and ends of the brace until it fits properly.
Page 16
MINIMOA - INSTRUCTION MANUAL Item code: BH88. left wing. C/A glue. Cut. Plastic parts of rudder and elevator pushrod. C/A glue Cut.
Page 17
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Top side. INSTALLING THE FUSELAGE TOP HATCH. Cut. Epoxy glue. C/A glue C/A glue Epoxy glue.
Page 18
MINIMOA - INSTRUCTION MANUAL Item code: BH88. Top side. C/A glue BALANCING. 1) It is critical that your airplane be bal- anced correctly. Improper balance will cause your plane to lose control and crash.
6) Properly balance the propeller. We wish you many safe and enjoyable flights with your MINIMOA. CONTROL THROWS. 1) We highly recommend setting up a ...
Need help?
Do you have a question about the MINIMOA and is the answer not in the manual?
Questions and answers