Led Indicators - Moxa Technologies NPort IAW5000A-I/O Series Quick Installation Manual

LED Indicators

Name
PWR 1,
PWR 2
Ready
WLAN (Only for
the NPort
IAW5000A-I/O)
Signal Strength
(3 LEDs only for
the NPort
IAW5000A-I/O)
Ethernet
P1, P2 (Serial)
DI
DO
Color Function
Green Power is being supplied to power input PWR1,
PWR2.
Red Steady on Power is on, and the NPort is
Blinking
Flashing
quickly
Green Steady on Power is on, and the NPort is
Blinking
Off Power is off, or a power error condition exists.
Green Steady on Wireless is enabled
Blinking
Off Wireless is not enabled.
Green 1 Bottom
2 Middle
3 Top
Amber 10 Mbps Ethernet connection
Green 100 Mbps Ethernet connection
Off The Ethernet cable is disconnected or has a
short.
Amber Serial port is receiving data.
Green Serial port is transmitting data
Off No data is being transmitted or received
through the serial port.
Green DI status on
Off DI status off
Green DO status on
Off DO status off
booting up.
Indicates an IP conflict, or the
DHCP or BOOTP server did not
respond properly, or a relay
output occurred.
When the above two conditions
occur at the same time.
Check the relay output first. If the
Ready LED is still blinking after
resolving the relay output, then
there is an IP conflict, or the DHCP
or BOOTP server did not respond
properly.
microSD card failed
functioning normally.
The device server has been
located by Administrator's
Location function
NPort can't establish WLAN
connection with AP
(Infrastructure) or station
(Ad-Hoc)
The signal strength (RSSI) is less
than -74 dBm
The signal strength (RSSI) is
between -65 to -74 dBm
The signal strength (RSSI) is
greater than -65 dBm
- 4 -