Led Indicators; Specifications - Moxa Technologies AWK-1127 Quick Installation Manual

LED Indicators

The front panel of the Moxa AWK-1127 contains several LED indicators.
The function of each LED is described in the table below.
LED Color
PWR Green
FAULT Red
Green/
STATE
Red
SIGNAL
Green
(5 LEDs)
WLAN
Green
LAN
Green
Green
TX/RX
Amber

Specifications

WLAN Interface
Standards
State Description
On Power is on.
Off Power is not being supplied
On System is booting up
Blinking Cannot get an IP address from the
(slow at DHCP server.
1-second
intervals)
Blinking IP address conflict.
(fast at
0.5-second
interval)
Off Status is normal.
System startup is complete and the
Green
system is in operation.
Green The device has been located by the
(Blinking at Wireless Search Utility.
1-second
intervals)
Red System is booting up.
On Signal level
Off Reserved
On WLAN has been established.
Blinking WLAN is transmitting data.
Off WLAN is not working properly.
On 100/10 Mbps LAN port is active.
Blinking Data is being transmitted.
Off 100/10 Mbps LAN port is inactive.
On Serial port is transmitting data.
No data is being received through the
Off
serial port.
On Serial port is receiving data.
No data is being transmitted through
Off
the serial port.
IEEE 802.11a/b/g for Wireless LAN
IEEE 802.11i for Wireless Security
IEEE 802.3 for 10BaseT
IEEE 802.3u for 100BaseT(X)
IEEE 802.3af for Power-over-Ethernet (PoE models
Only)
IEEE 802.1D for Spanning Tree Protocol
IEEE 802.1w for Rapid STP
- 10 -