Notify your sales representative if any of the above items are missing or damaged. Hardware Introduction As shown in the following figures, the NPort IA5000A-I/O Series has two Ethernet RJ45 LAN ports, and the NPort IAW5000A-I/O Series has one Ethernet RJ45 LAN port and one antenna for WiFi (IEEE 802.11 standards) signal communication, supporting 2.4GHz and 5 GHz frequencies.
NPort IA5000A-I/O Series The mechanical design of the NPort IA5000A-I/O Series is mostly identical; only the number of serial ports and number of DI/DO channels differ. NPort IAW5000A-I/O Series The mechanical design of the NPort IAW5150A and the NPort IAW5250A is mostly identical;...
Check the relay output first. If the Ready LED is still blinking after resolving the relay output, then there is an IP conflict, or the DHCP or BOOTP server did not respond properly. Flashing microSD card failed quickly Green Steady on Power is on, and the NPort is functioning normally.
Page 5
STEP 1: Insert STEP 2: The the top of the DIN rail DIN rail into the attachment unit slot. will snap into place as shown at right. Wall Mounting (optional) For some applications, it may be more convenient to mount the NPort IA5000A-I/O or IAW5000A-I/O to a wall, as illustrated below.
Use HyperTerminal or a similar program (you may download • Moxa’s program, called PComm Lite) to test whether the device is good or not. Setting the IP Address The factory default IP settings are assigned as follows: NPort IA5000A-I/O Series Netmask Static 192.168.127.254 255.255.255.0 NPort IAW5000A-I/O Series...
WLAN Netmask Static 192.168.127.254 255.255.255.0 If the NPort is configured for DHCP but the DHCP server cannot be found, the NPort will use factory default IP settings. NOTE If you have forgotten the NPort’s IP address, use the Device Search Utility from your PC to locate the NPort. After searching the LAN for NPort units, the Device Search Utility will display the IP address of each unit.
DB9 Male (RS-232/422/485) RS-422/ RS-232 RS-485-2W RS-485-4W TxD-(A) – TxD+(B) – RxD+(B) Data+(B) RxD-(A) Data-(A) – – – – – – – – – Power Input and Relay Output Pinouts DC Power DC Power DC Power DC Power N.O. Common N.C.
Page 9
FCC Part 15 Subpart B, Class A Safety UL: UL 60950-1 LVD: EN 60950-1 DSPR: ARIB-STD 33, ARIB-STD 66 Fault Relay Circuit 3-pin circuit with current-carrying capacity of 2 A @ 30 VDC ATTENTION This product is intended to be supplied by an UL listed DC source suitable for use at TMA of 60 degree C, which output meets SELV circuit and LPS, which is separated from the primary circuit by double insulation or reinforced insulation, and is rated 12-48Vdc,...