Hardware Introduction; Led Indicators - Moxa Technologies NPort 6450 Series Quick Installation Manual

NOTE The installation instructions indicate use in a RESTRICTED
ACCESS LOCATION only.

Hardware Introduction

NOTE The LCD panel is only available with standard temperature
models.
Reset Button—Press the Reset button continuously for 5 sec to load
factory defaults. Use a pointed object, such as a straightened paper clip or
toothpick, to press the reset button. This will cause the Ready LED to blink
on and off. The factory defaults will be loaded once the Ready LED stops
blinking (after about 5 seconds). At this point, you should release the
reset button.

LED Indicators

Name Color
PWR Red
Ready Red
Green
Off
Link Orange
Green
Off
Function
Power is being supplied to the power input.
Steady on: NPort is booting up.
Blinking: IP conflict, DHCP or BOOTP server
problem, or relay output problem.
Steady on: Power is on and the NPort 6450 is
functioning normally.
Blinking: NPort is responding to Locate
function.
Power is off, or power error condition exists.
10 Mbps Ethernet connection.
100 Mbps Ethernet connection.
Ethernet cable is disconnected, or has a short.
- 3 -