Led Indicators - Moxa Technologies NPort 6150 Series Quick Installation Manual

NPort 6250
Reset Button—Press the Reset Button continuously for 5 sec to load
factory defaults. Use a pointed object, such as a straightened paper clip
or toothpick, to press the reset button. This will cause the Ready LED to
blink on and off. The factory defaults will be loaded once the Ready LED
stops blinking (after about 5 seconds). At this point, you should release
the reset button.

LED Indicators

LED Name LED Color
PWR
Ready
LED Name LED Color
Link
P1, P2
LED Function
Red Power is being supplied to the power input.
Steady on
Blinking
Red
Steady on
Green
Blinking
Off Power is off, or power error condition exists.
LED Function
Orange 10 Mbps Ethernet connection
Green 100 Mbps Ethernet connection
Ethernet cable is disconnected, or has a
Off
short.
Orange Serial port is receiving data.
Green Serial port is transmitting data.
No data is being transmitted or received
Off
through the serial port.
Power is on and the NPort is
booting up.
Indicates an IP conflict, or, the
DHCP or BOOTP server did not
respond properly or a relay
output occurred. Check the relay
output first. If after resolving
the relay output the RDY LED is
still blinking, then there is an IP
conflict, or the DHCP or BOOTP
server did not respond properly.
Power is on and the NPort is
functioning normally.
The device server has been
located by the Administrator's
Location function.
- 3 -