Temperature Control; Shakingcontrol - Jeio tech ISF-7100 Operating Manual

4.2.1 Temperature control

(1) Start temperature control
Touch the set temperature button on the main display. Setting display is appeared. Set the temperature
with touch pad and touch the start button. The temperature control starts. SV and PV is displayed on the
main display with green color.
(2) Stop the temperature control
Touch the set temperature button. Setting display is appeared. Touch the stop button. The temperature
control stops. The temperature control starts. SV and PV is displayed on the main display with gray color.
(3) Change the set temperature
Touch the set temperature button. Setting display is appeared. Put the setting value on the touch pad and
touch the enter button. SV is changed.

Temperature setting is one digit and one decimal point available. Touch the panel and put the
numbers.

Move out from the setting mode with ESC button.

In the case of no touch for 10 seconds, the display changed to the main automatically.

Check the PV, RPM on the setting display is available. (right upper side)

The operating is maintained as previous during the setting.

Once the door is opened during the shaking operating, the heater and fan is stopped. Close the
door before door error generating, the previous operating is back.
4.2.2 Shaking Control
(1) Start shaking control
Touch the Set RPM Button under the shaking stop status. Setting mode is appeared. Set the value on the
display and touch the Start button. Shaking control starts. SV/PV rpm is changed to green color.
(2) Stop the shaking control.
Touch the Set RPM button under the shaking operating status. Setting mode is appeared. Touch the Stop
button. Shaking stops. SV/PV rpm is changed to gray color.
(3) Change the shaking speed
Touch Set RPM button. Setting mode is appeared.
Set the value on the display and touch the Enter button. The rpm is changed.
２２