At/Atx Mode Selection; Figure 3-24: Iris-2400 Module Installation - IEI Technology PPC-F A-H81 Series User Manual

PPC-FxxA-H81 Panel PC
Align the iRIS-2400 module with the iRIS-2400 module slot. Align the notch
Step 3:
on the module with the notch on the iRIS-2400 module slot (Figure 3-24).

Figure 3-24: iRIS-2400 Module Installation

Insert the iRIS-2400 module. Push the module in at a 20º angle (Figure 3-24).
Step 4:
Seat the iRIS-2400 module. Gently push downwards and the arms clip into
Step 5:
place (Figure
NOTE:
After installing the iRIS-2400 module, use the LAN port with iRIS label
(Figure 1-4) to establish a network connection. Please refer to
Section 3.13 for IPMI setup procedures.

3.10 AT/ATX Mode Selection

AT and ATX power modes can both be used on the PPC-FxxA-H81 panel PC. The
selection is made through an AT/ATX switch on the I/O interface panel. The switch is
shown below.
3-24).Step 0:
Page 37