At/Atx Power Mode Selection - IEI Technology IRS-100-ULT3 User Manual

IRS-100-ULT3 Railway Surveillance System
3.5 Configuring the System Settings
The system configuration is controlled by buttons/jumpers/switches, and should be
performed before installation. To configure some of the jumper settings, the user has to
open the bottom cover. Please refer to Section 3.4 for details.

3.5.1 AT/ATX Power Mode Selection

AT or ATX power mode can be configured on the IRS-100-ULT3. The selection is made
through an AT/ATX switch located on the rear panel (Figure 3-2).
Figure 3-2: AT/ATX Mode Selection Switch Location
Page 16