Operating Multiple Cameras With The Infrared Remote Controller; Adjusting The Camera - Marshall Electronics CV610-U3-V2 User Manual

Zooming
Press either of the ZOOM buttons.
Note
When you perform pan/tilt operation while the camera is
in the telephoto mode, the moving speed of the image on
the screen may be a little jerky.
8.2 Operating Multiple Cameras with the
Infrared Remote Controller
1. Set the DIP Switch on the bottom of the camera to the
number of camera you want to operate to 1, 2 or 3.
(See bottom DIP Switch setting instruction)
2. Press the CAMERA SELECT button on the infrared
remote controller that corresponds to the number
set in step 1.
Then, you can operate the camera(s) specified by number.
Every time you operate the camera(s) using the infrared
remote controller, the CAMERA SELECT button pressed
in step 2 lights.

8.3 Adjusting the Camera

Focusing on a Subject
Focusing the camera on a subject automatically
Press the M button.
The camera focuses on the subject at the center of the screen
automatically.
Focusing the camera on a subject manually
After pressing the MENU button, press either the FAR or the NEAR
button to have the camera focus on the subject.
Shooting with Back Lighting
When you shoot a subject with a light source behind it, the subject
becomes dark. In such a case, press the BACK LIGHT button.
To cancel the function, press the BACK LIGHT button again.
Note
The BACK LIGHT function is effective if MODE is set to FULL AUTO in the EXPOSURE menu of the
camera.
31