Table of Contents
Advertisement
Use RS-422(VISCA) / RS485 (PELCO P/D)
You can use RS-422/485 port connect to optional controllers, such as joystick control keyboard,
control PC station, to operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform
the Preset operation using the control buttons.
An application software that supports this unit is needed if you use PC station.
RS422/482 Connection
RS422 (VISCA) connection
1. Set Bottom DIP Switch SW1-B6 to OFF. (See page 18).
2. Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you
are using.
(See page 18).
3. Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4. Does not need setting camera address in way of RS422(VISCA) controlling.
5. The controller must be VISCA compatible.
6. Camera supports Daisy Chain connection up to 7 cameras.
7. The connection of SONY keyboard is different than other VISCA (None-Sony) keyboard.
SONY Keyboard RS422 Connection
17
Advertisement
Table of Contents
