Table of Contents
Advertisement
Precautions for Preventing Access to the Camera by an Unintended Third Party
The camera can be fraudulently accessed in a network environment where a device is connected
or connectable to the network without the administrator's permission, or a PC or other network
device connected to the network can be used without any permission. If the computer to check
USB images is connected to a network, there may be a risk of information leaks, obstructed viewing
due to infection by a virus, or other risks. Connect to these environments at your own risk.
6. Bottom Dip Switch Settings
The bottom dip switch is for setting the camera configuration for following items:
1.
Camera ID Address for VISCA protocol
2.
Video output / Video color space
3.
RS-232 / RS-422/485 selection
4.
Video resolutions selection
5.
IR remote controller ID
Setting of the BOTTOM DIP Switches
Turn off power to the camera before changing the DIP switch settings.
From the above list, The NO.1 Camera ID address is for VISCA protocol up to 7. The camera
ID address for PELCO P/D protocol can be set on camera OSD menu. NO.2 Video resolution
settings can be set in camera OSD menu as well. The camera takes either the way of OSD menu
setting or the way of bottom DIP switch setting. They override each other. After the camera is
turned on, the camera takes the last setting before it is turned on, either set through the OSD or
bottom DIP switch.
The DIP Switch Settings
Bit 1~3:
Camera Address setting for VISCA protocol
Bit 4:
Video Color Space
Bit 5:
Reserve
Bit 6:
Reserve for System firmware upgrade
Bit 7~8:
RS-232/RS-422 Baud Rate
www.marshall-usa.com
CV610-U3-V2 Manual
20
Advertisement
Table of Contents
