Table of Contents
Advertisement
Chapter 7, Description of Fields
Fields That Begin with the Letter T
Tune Mode
TX Freq Error
276
This field is displayed on the screens listed below when the RF Display field on
the CONFIGURE screen is set to "Freq".
This field selects Automatic or Manual tuning of the RF Analyzer.
tuning causes the RF Analyzer to find the signal with the greatest amplitude
Auto
>-36 dBm, and to set the Tune Frequency for that signal.
tuning requires the operator to set the Tune Frequency for the RF signal
Manual
to be analyzed.
Operating Considerations
Changing the
Tune Mode
tuning enables the
TX Frequency
measurement.
TX Freq Error
After autotuning to the desired signal, select
from changing when the signal is no longer applied.
Tune Freq
Screens Where Field is Present
ANALOG MEAS
This field is displayed when Freq is selected in the RF Display field, and Manual
is selected in the Tune Mode field.
This field displays the frequency error (error = assigned carrier frequency -
measured carrier frequency) of the carrier being transmitted by the mobile station.
Four dashes (----) indicates that there is no carrier frequency present to measure.
Screen(s) Where Field is Present
CALL CONTROL
ANALOG MEAS
also changes the RF frequency display. Automatic
measurement. Manual tuning enables the
Manual
tuning to prevent the
Advertisement
Table of Contents
