Table of Contents
Advertisement
Register
Selecting this field causes the mobile station to perform a zone-based registration.
The Test Set first transmits an alternate SID/NID pair that causes the mobile
station to respond by registering, as if the mobile station were moving into a new
zone. This SID/NID pair, used in the System Parameters Overhead Message,
settable (see
Rgstr NID field description, on page 256
description, on page 257
After the mobile station has registered the first time, the Test Set sends another
SID/NID pair, this time using the values set in Network ID and System ID fields
(see the
"CDMA Cell Site Configuration Screen" field on page 119
main SID and NID, and the mobile station will register again and set its roam
status according to these values.
Operating Considerations
Mobile station registration can occur as a result of the following events:
•
The mobile station power is cycled
•
The "Register" feature is selected by selecting this field or sending the HP-IB command
shown above.
•
A call is made by pressing the CALL key with the MS ID mode Auto.
•
A mobile-station initiated call is made. This event causes an implicit registration to be
performed.
When the
field is selected, the
Register
until the registration is successful, or the registration attempt times-out.
See Also
"Setting up a Call"
chapter in the HP 8924E Introduction to Operation
Screen(s) Where Field is Present
CDMA CALL CONTROL
Fields That Begin with the Letter R
).
Registering
Chapter 7, Description of Fields
and
Rgstr SID field
). These are the
annunciator will light
243
Advertisement
Table of Contents
