Tilt Up And Tilt Down - TOHATSU MFS 9.9E Owner's Manual

3. Tilt up the outboard motor.
4. Remove the thrust rod as shown pic-
ture.
5. Reinstall the thrust rod in the desired
position securely.
6. Gentry tilt down the outboard motor.
2
1. Push in
2. Rise the stopper
3. Pull out
Trim angle adjustment (Power tilt type)
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Lock the tilt stopper.
5. Change the trim lock pin position as
shown in the picture.
1
1
3
ENOF01238-1
2 2
3
ENOF01426-0
1. Trim lock pin
2. Higher
3. Lower
6. Reinstall the trim lock pin securely.
7. Operate the Power Tilt switch and tilt
down the outboard.
ENOM00060-B
8. Tilt up and down
ENOW00055-1
WARNING
Do not tilt the outboard motor up or down
when swimmer(s) and/or passenger(s) are
near to prevent them from being caught
between outboard motor body and clamp
bracket.
ENOW00048-1
WARNING
When tilting up or down, be careful not to
place your hand between the swivel bracket
and the clamp bracket.
ENOW00056-A
WARNING
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-1
CAUTION
Do not tilt up the outboard motor while
engine is operating, or no cooling water may
be discharged, leading to engine seizure due
to overheating.
ENGINE OPERATION
47
7