TOHATSU MFS 9.9E Owner's Manual page 69

ENOM00098-A
Gear oil replacement
ENOW00076-1
WARNING
Be sure that the outboard motor is
secured to transom or service stand, or
accidental drop or fall of outboard motor
could lead to severe personal injury.
Be sure to lock the outboard motor in the
tilt up position, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
Do not go under outboard motor in the tilt
up position and locked, or accidental fall
of outboard motor could lead to severe
personal injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
flows out of the upper plug hole and
bubbles is disappeared to remove the
air.
4. Install the upper oil plug, and then
Oil plug specified tightening torque
4N·m (3 ft
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOF01244-0
INSPECTION AND MAINTENANCE
ENON00033-1
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 465 mL (15.7
fl.oz.).
remove oil tube nozzle and install the
lower oil plug.
· ·
lb, 0.4 kgf m)
CAUTION
69
ENOF01245-0
10