TOHATSU MFS 9.9E Owner's Manual page 61

2. Remove the flushing connector cap
from the outboard motor, and screw
in the hose joint.
3. Connect a water hose. Turn on the
water and adjust the flow.
Continue flushing the outboard motor
for 3 to 5 minutes
4. After the flushing, be sure to reattach
the flushing connector cap.
5. Tilt up the outboard motor.
.
1. Hose joint
ENOM00085-A
Flushing by test tank
ENOW00081-1
WARNING
Do not start engine without removing pro-
peller, turning propeller out in the open may
lead to personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors or
in any space which is not well ventilated.
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be fatal
if inhaled for any length of time.
ENOW00036-1A
When starting the outboard motor in the
test tank, make sure that:
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
2. Run at idling only
3. Remove the propeller
(See page 70)
3
2
1. Test tank
1
2. Water
3. Over 10 cm (4 in.)
ENOF01223-1
ENOM00950-1
Fuse replacement
ENOW00923-1
Before replacing a fuse, disconnect the bat-
tery cable from the battery negative (-) ter-
minal first. Failure to properly remove
battery cables may cause a short-circuit.
ENOW00924-0
Never use a fuse with a rating that exceeds
the specified rating as this could cause seri-
ous damage to the electrical system.
If the fuse has blown, try to determine
INSPECTION AND MAINTENANCE
CAUTION
CAUTION
CAUTION
61
1
ENOF00863-0
10