Table of Contents
Advertisement
1. Trim angle adjustment hole
2. Thrust rod
3. Higher
4. Lower
Trim angle adjustment
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Remove the thrust rod as shown pic-
ture.
2
1. Push in
2. Rise the stopper
3. Pull out
5. Reinstall the thrust rod in the desired
position securely.
6. Gentry tilt down the outboard motor.
1
2
4
3
ENOF00440-0
1
3
ENOF01238-1
ENOM00060-A
8. Tilt up and down
ENOW00055-1
WARNING
Do not tilt the outboard motor up or down
when swimmer(s) and/or passenger(s) are
near to prevent them from being caught
between outboard motor body and clamp
bracket.
ENOW00048-1
WARNING
When tilting up or down, be careful not to
place your hand between the swivel bracket
and the clamp bracket.
ENOW00056-A
WARNING
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-1
CAUTION
Do not tilt up the outboard motor while
engine is operating, or no cooling water may
be discharged, leading to engine seizure due
to overheating.
ENON00921-1
Note
After use, leave the outboard motor
upright for a minute to drain the water
from inside the engine.
ENOM00423-0
Tilt up
With the shift lever in Forward, fully tilt
the motor up toward you by holding the
tilt handle provided at the rear of the top
ENGINE OPERATION
39
7
Advertisement
Table of Contents
