Table of Contents
Advertisement
1
3
1. Bolt (8 × 85)
2. Nylon locking nut
3. Washer
4. Clamp screw
ENOW00945-0
CAUTION
Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
Loosening may cause a dangerous situa-
tion, such as loss of control.
EPT type
1. To attach the outboard motor to the
boat, use the bolts to secure the out-
board motor brackets on transom
board.
1
2
1. Bolt (8 × 85)
2. Washer
3. Nylon locking nut
2
3
4
ENOF00016-2
2
3
ENOF00507-2
194
152
187
193
ENOW00008-2A
CAUTION
Tighten the bolts securely, otherwise the
outboard motor could fall down.
ENON00003-2
Notes
1.
Apply sealing material, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. For EP / EFT type, drill the holes in
transom board only at left and right of
lower side of clamp bracket, and
attach outboard motor with supplied
bolts.
For EPT type, drill the holes in transom
board at 4 points up and down, right
and left, and attach outboard motor
with supplied bolts.
Do not reuse Nylon locking nut.
INSTALLATION
23
ENOF00305-0
5
Advertisement
Table of Contents
