Table of Contents
Advertisement
68
INSPECTION AND MAINTENANCE
1
1. Drain screw
2. Drain port
3. Loosen
4. Tighten
In case of debris
1. If present, disconnect hoses from the
fuel connector (male) and the fuel
pump.
2. Remove the cup, filter and O-rings
from the fuel filter body.
3. Check the wear and clogging for each
parts, and replace if necessary.
4. Remove fuel and any water or debris
from the cup, filter and hoses.
5. Reassemble all parts.
1
10
2
3
4
5
6
1. Body
2. O-ring
2
3
4
ENOF01242-1
ENOF01243-0
3. O-ring
4. Filter
5. Float
6. Cup
7. Indicate of Fuel Flow
ENOM00096-A
Fuel filter (for fuel tank)
Water or dirt in the fuel tank will cause
engine performance problems.
Check and clean the tank at specified
times or after the outboard motor has
been stored for a long period of time
(over three months).
1. Remove the fuel pickup elbow of the
fuel tank by turning it counterclock-
wise
2. Clean the fuel filter and check the O-
ring. Replace it if necessary.
3. Reassemble all parts.
7
1. Fuel pick up
2. Filter
1
2
ENOF01226-A1
Advertisement
Table of Contents
