TOHATSU MFS 9.9E Owner's Manual page 66

66
INSPECTION AND MAINTENANCE
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 29)
Oil volume needed for complete oil replacement
With oil filter replace-
ment
Approximately 1200 mL
(40.6 fl.oz.)
ENOW00925-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
If any amount of water is found in
engine oil, making it milky white, consult
dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
10
cially in cooler water temperatures.
Without oil filter
replacement
Approximately 1000 mL
(33.8 fl.oz.)
CAUTION
ENOM00092-A
Oil filter replacement
ENOW00091-1
CAUTION
You may be injured due to high engine tem-
peratures if you fill engine oil just after oper-
ation. Engine oil should be changed after the
engine has been cooled.
ENOW00926-0
CAUTION
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
1. Drain oil from the engine.
2. Place a rag or towel below the oil fil-
ter to absorb any spilled oil.
3. Unscrew old filter by turning the filter
to counter-clockwise.
4. Clean the mounting base. Apply film
of clean oil to O-ring.
Do not use grease.
Install oil filter and tighten it to specified
torque by using oil filter wrench.
Oil filter torque:
18 N·m (13 ft lb, 1.8 kgf
·
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
m)
·