Tilt Up And Down - TOHATSU EverRun MX 25H Owner's Manual

38
ENGINE OPERATION
Trim angle adjustment
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Remove the thrust rod as shown pic-
ture.
2
1. Push in
7 2. Rise the stopper
3. Pull out
5. Reinstall the thrust rod in the desired
position securely.
6. Gentry tilt down the outboard motor.
ENOM00060-A

8. Tilt up and down

ENOW00055-1
Do not tilt the outboard motor up or down
when swimmer(s) and/or passenger(s) are
near to prevent them from being caught
between outboard motor body and clamp
bracket.
3
ENOF01238-1
WARNING
ENOW00048-1
When tilting up or down, be careful not to
place your hand between the swivel bracket
and the stern bracket.
ENOW00056-A
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
1
ENOW00057-1
Do not tilt up the outboard motor while
engine is operating, or no cooling water may
be discharged, leading to engine seizure due
to overheating.
ENON00921-1
Note
After use, leave the outboard motor
upright for a minute to drain the water
from inside the engine.
ENOM00062-1B
Tilt up
Push the reverse lock lever down until it
stops. (This is the tilt up position.) Then,
tilt the outboard motor all the way up
until it is locked in place.
WARNING
WARNING
CAUTION