TOHATSU MFS 9.9E Owner's Manual page 87

ENOM00034-B
EPA pressurized portable
fuel tank requirements
FOR UNITED STATES AND CANADA
MODEL
The Environmental Protect ion Agency
(EPA) required portable fuel tank that use
with outboard engines produced after
January 1, 2011 for to remain fully sealed
(pressurized) up to 34.4 kPa (5.0 psi).
These tanks may contain the following:
An air inlet that opens to allow air to
enter as the fuel is cam be supplied to
the engine.
An air outlet that opens (vents) to the
atmosphere if pressure exceeds 34.4
kPa (5.0 psi). A hissing noise may be
heard as the tank vents to the atmo-
sphere. This is normal.
When installing the fuel tank cap, turn
the cap to the right until you hear two
clicks. This signals that the fuel cap is
fully seated. A built-in device prevents
overtightening.
The fuel tank has a manual vent screw
which should be closed for transporta-
tion and full open for operation and
cap removal.
Since sealed fuel tanks are not openly
vented, they will expand and contract as
the fuel expands and contracts during
heating and cooling cycles of the outside
tempelatur. This is normal.
EMISSION CONTROL SYSTEM INFORMATION
ENOM00036-0
EPA approval Primer bulb/
hose assembly
EQUIPPED FOR UNITED STATES AND
CANADA MODEL
TOHATSU adopts Primer bulb/hose
assembly approved by the Environment
Protection Agency (EPA).
Please use the EPA approved primer
bulb/hose assembly with the identifica-
tion mark on the fuel connector.
ENOW00021-0
CAUTION
Be sure to use EPA approved tank and EPA
approved primer bulb/hose assembly as a
set. Confirm shapes of EPA approved tank
and regular tank.
1
1. Except for U.S. model (regular tank)
2. For U.S. and Canada model (EPA approved tank)
87
ENOF00111-0
2
ENOF00024-1
14