Panduit PANZONE PZWMC Instructions Manual page 9

Installation (continued)
• Install the remaining parts in the following order:
Direction Setting Washer, Cam (saved from previ-
ous lock), Flat Washer, Lock Washer, and Retain-
ing Screw. (Figure 7)
• Set the lock to the factory combination 0-0-0.
•
Test lock rotation direction. Adjust cam angle if
necessary
To Change Combination:
• Set the lock to the previous combination or factory
combination (0-0-0).
• Push reset button with pin. (Figure 9)
• While reset button is pushed, scroll numbers to
the desired combination. (Figure 9)
• Release the reset button to set the combination.
To Hide the Reset Button:
• Set the lock to the desired combination.
• Remove the direction setting washer, cam. flat
washer. lock washer, and retaining screw. (Figure
12)
• Pull out the lock head and rotate 180º. (Figures
10-11)
• Reinstall the direction setting washer, cam, flat
washer, lock washer, and retaining screw. (Figure
12)
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTRUCTIONS CM315E
Push reset button with pin
Reset
Button
Spacer Ring
Lock
Head
Figure 10
Cam
(saved)
from pre-
vious lock)
Page 9 of 11
Lock
Cam
Washer
(saved)
from pre-
vious lock)
Direction
Setting
Washer
Scroll numbers to
desired combination
Lock
Washer
Flat
Washer
Direction
Setting
Washer
Retaining
Screw
Flat
Washer
Figure 8
Figure 9
Figure 11
Retaining
Screw
Figure 12