Page 2
M5 Thread forming M4 Thread forming Hinge screws & lock- Mounting Rail Latch screws washers Lock Hole Grommet Lock Mounting Hardware Mounting Rails are adjustable in Lock in downward 0.9” increments. rotation For Technical Support: www.panduit.com/resources/install_maintain.asp Page 2 of 7...
Page 3
. Route to the desired patch panel after securing the cables with a T at point 3 or 4. Point 4 Point 2 Point 3 Point 1 Cables Extend to Patch Panel For Technical Support: www.panduit.com/resources/install_maintain.asp Page 3 of 7...
PZCFK PZBR4 Rail Kit Fan Kit 4” Bend Radius Post Kit PZBR3 PZCFR 3” Bend Fan Media Radius Post Kit replacement Kit PZCHSM2 PZBR3.5 Horizontal 3.5” Bend Slack Manager Radius Post Kit For Technical Support: www.panduit.com/resources/install_maintain.asp Page 4 of 7...
Page 5
Note: When using switches with side air intake and opposite side exhaust use one fan without fan blank Mounting Rail Installation (PZWMC12RR) Mounting Rail To install mounting rail use (2) M6 thread forming screws & lockwashers at desired location as shown below Mounting Hardware For Technical Support: www.panduit.com/resources/install_maintain.asp Page 5 of 7...
Figure 2 Bend Radius Post Score Line #12-24 x 2.5" Screw Recommended Layout 24 Port Patch Panel 24 Port Patch Panel PZCHSM2 24 Port Patch Panel 24 Port Patch Panel PZCHSM2 Active Equipment For Technical Support: www.panduit.com/resources/install_maintain.asp Page 6 of 7...
Page 7
Routed to top Horizontal to lower slack manager. Slack Manager For instuctions in Local Languages E-mail: and Technical Support: cs@panduit.com Fax: www.panduit.com/resources/install_maintain.asp (708)444-6448 www.panduit.com Page 7 of 7...