Kit Contents; Mounting Cutout; Installation - Panduit PANZONE PZWMC Instructions Manual

P Z Lock Kits (PZWMC-CL)
AN ONE

Kit Contents

• Combination locks (2)
• Spacer rings (2)
• Cylinder nuts (2)
• Retaining screw (2)
• Lock washers (2)
• Flat washers (2)
• Direction setting washers (2)
.640
.650

Mounting Cutout

Installation

• Remove the existing locks from the cabinet and save
cams for later use. (Figure 2)
• Remove the Cylinder Nut from the Combination Lock
and insert the Spacer Ring over the Lock Cylinder.
(Figure 3)
• Install the Combination Lock onto the Cabinet and
tighten the Cylinder Nut. The Lock Head should be
spaced away from the Cabinet Surface. (Figures 3 &
4)
• Remove the Retaining Screw, Lock Washer, Flat
Washer, and Direction Setting Washer.
• Pull the Lock Head from the cylinder and rotate until
oriented in the desired direction. (Figures 5-7)
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTRUCTIONS CM315E
Combination locks Combination locks
including Cylinder Nut, including Cylinder Nut,
Retaining Screw, Lock Retaining Screw, Lock
Washer, Flat Washer and Washer, Flat Washer and
Direction Setting Washer Direction Setting Washer
.755
DIA.
.765
Cam
from
lock
Figure 2
Lock
Head
Cylinder Nut
Installed on
Back of Cabinet
Figure 4
Cam will
rotate
right
Direction Setting Washer
Page 8 of 11
Cam Lock Spacer Cam Lock Spacer
Rings Rings
Spacer Ring
Lock
Cylinder
PZWMC* Cabinet
Surface
Combination Lock Head
Spacer RIng
Figure 5
Figure 1 Figure 1
Cylinder Nut
Figure 3
Figure 6
Cam will
rotate left
Figure 7