© Panduit Corp. 2011
Retro-Fit Kit Components:
Door
This Retro-Fit Kit is designed specifically for use with the PZWIFIED Wireless Enclosure.
Door Replacement
Step 1: Disconnect grounding wire from door to be removed. See Figure 1.
Step 2: Remove lock from door by removing nut on inside door face. See Figure
1.
Step 3: Remove hinge pins from door to be removed using a hammer and a small
gauge steel pin. See Figure 1.
Step 4: Remove old door. See Figure 1.
Step 5: Align hinges of new door to enclosure. See Figure 2.1.
Step 6: Add hinge pins to assembly using a hammer and a small gauge steel pin.
See Figure 2.2.
Step 7: Reconnect grounding wire. See Figure 2.3.
Step 8: Reinstall lock onto door. Be sure to maintain the same lock orientation
as when it was removed in Step 2. See Figure 2.3.
Figure 2.1
Figure 2.2
Retro-Fit Kit for P
Part Number(s): PZWRKA
INSTALLATION INSTRUCTIONS
(4) #8-32 X 1/4"
Screws
(4) #8-32 Hex Nuts
Mounting Bracket
Door Hinges
New Door
Hinge Pins-Install using
hammer and small gauge
steel pin
For Technical Support: www.panduit.com/resources/install_maintain.asp
Z
AN
ONE
(2) Hinge Pins
Grounding Wire
Remove lock
from old door
Grounding Wire
Lock
Page 1 of 2
Wireless Enclosure
Complete In-Ceiling Enclosure
Assembly with Retro-fit Parts
and Wireless Access Point
Hinge Pins-Remove using
hammer and small gauge
steel pin
Figure 1
Figure 2.3
CM545
Door to be
removed