Omcan VP-NL-3016-SN Instruction Manual page 20

Troubleshooting
The machine does not seal.
The service symbol appears when
turning on the machine, indicating
the remaining production hours or
cycles.
The bag is not correctly positioned
over the sealing beam.
The sealing wire is broken.
The thermal safety of the power
supply was tripped.
The electrical contacts of the seal
beam have fouled.
The service interval counters
have reached their maximum
programmed values.
20
Adjust the bag position.
Replace the sealing wire.
Wait until the safety resets, which
can take half an hour. Decrease
the sealing time.
Remove the seal beam and clean
the pins and contacts with sand
paper.
To reset the service interval
counters after the oil change: Start
the machine and while the display
shows the hours or cycles, press
and hold the "X" button.