Installing The Micro-Sd Card - Dell EMC PowerEdge R250 Installation And Service Manual

4. Remove the IDSDM module.
Steps
1. Locate the Micro-SD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information about the slot location, see
2. Hold the Micro-SD card and remove it from the slot.
NOTE: Temporarily label each Micro-SD card with its corresponding slot number after removal.
Figure 59. Removing the Micro-SD card
Next steps
Replace the MicroSD cards.

Installing the Micro-SD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
NOTE: To use a Micro-SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: Ensure that you install the Micro-SD cards into the same slots based on the labels you had marked on the cards
during removal.
Steps
1. Locate the Micro-SD card slot on the IDSDM module. Orient the Micro-SD card appropriately and insert the contact-pin end
of the card into the slot. To locate IDSDM, see the
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the slot to lock it into place.
62 Installing and removing system components
System board jumpers and connectors section.
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
section.