Cannot Connect To The Scansnap Even After The Installation Has Been Complete (Ix1600 / Ix1500) - Fujitsu ScanSnap iX1400 Basic Operation Manual

Cannot Connect to the ScanSnap even after the
Installation Has Been Complete (iX1600 / iX1500)
If the ScanSnap Manager icon in the notification area is
ScanSnap on the touch panel may not be complete.
Configure the settings of the ScanSnap by following the instructions on the touch panel.
1.
Select a display language for the touch panel and press the [Next] button.
2.
Select a startup mode on the [Startup Mode] screen and press the [Next]
button.
a The ScanSnap is connected to a computer and the ScanSnap Manager icon in the
notification area located at the far right of the taskbar changes from

Cannot Connect to the ScanSnap even after the Installation Has Been Complete (iX1600 / iX1500)

, configuring the settings of the
419
to .