Setting Up Ix100 - Fujitsu ScanSnap iX1400 Basic Operation Manual

Setting Up iX100

Set up the ScanSnap so that it is ready to scan with ScanSnap Manager.
The following preparations are required before you set up the ScanSnap.
l Check that all items are included in the package
For details, refer to
HINT
When Getting Started is included in the package, refer to "Package List" in Getting Started.
l Remove the tape seal (1) and tape (2) from the ScanSnap
1
l Connect the ScanSnap and the computer with a USB cable, and charge the battery until the
battery indicator light turns off
ATTENTION
- Do not open the feed guide until the instructions are displayed on the window for installing
software.
- The ScanSnap can be charged with the supplied USB cable or optional USB power adapter.
For details about purchasing the USB power adapter, refer to "Suppliers of Consumables/
Optional Parts" in
The procedure to set up the ScanSnap is as follows:
1. Downloading the Software
2. Installing the Software/Connecting the ScanSnap
3. Checking the Scanning Operation
"Package List for iX100" (page
2
"About Customer Support and Maintenance" (page
35).
31
Setting Up iX100
514).