Setting An Ip Address For The Scansnap (Ix1600 / Ix1500) - Fujitsu ScanSnap iX1400 Basic Operation Manual

Setting an IP Address for the ScanSnap (iX1600 / iX1500)

To identify your ScanSnap on a network, set an IP address for the ScanSnap.
When setting an IP address, [Access point connection] needs to be selected for [Wi-Fi connect
mode] temporarily.
1.
Press in the
display the [Settings] screen.
2.
Press
3.
Press [Access point connection] to display the [Access point connection]
screen.
4.
Press [IP address] to display the [IP address] screen.
5.
Press the setting field for [Configuration method] to display a list.
6.
Set an IP Address.
When obtaining an IP address from the DHCP server and automatically assigning it to the
ScanSnap, select [Obtain automatically (DHCP)].
When setting an IP addresses manually, select [Configure IP address manually] and configure
the following settings.
1. Press the input field for [IP address], enter the IP address, and then press [OK].
2. Press the input field for [Subnet Mask], enter the subnet mask, and then press [OK].
3. Press the input field for [Default Gateway], enter the default gateway, and then press [OK].
7.
Press to return to the home screen.
ATTENTION
If there is a device with the same IP address as the ScanSnap on the network,
in the [Settings] screen. Change the IP address which has been set for the ScanSnap to
avoid an IP address conflict on the network.
home screen on the touch panel of the ScanSnap to
to display the [Wi-Fi settings] screen.
Access Point Connect Settings (iX1600 / iX1500)
166
is displayed on